LilyCam
Hardware
- 4 Devlogs
- 3 Total hours
Im building a keychain camera inspired by the Kodak Chamera Keychain
30m 21s logged
Devlog #4 Hello everyone! The 3D is finished! I added a hole for the USB-C and the SD card. Created the lid and the half circle is for the keychain. that is all for today and I will submit it for funding very soon!
1h 14m 26s logged
Devlog #3 Hello everyone! Today, I have have put the button upside down and shorten the PCB a bit. Im continuing on with 3D model and as you can see the corner is rounded to reduce force on impact. That is all from me today.
29m 54s logged
Devlog 2 Hello everyone! today I have edited the PCB to fit all the parts so this is just a short devlog
1h 5m 16s logged
Devlog 1 Hello everyone! Yesterday I was doomscrolling then I found a post about a Kodak keychain camera and i want to build it, I will be using a XIAO ESP32-S3 Sense, 3x 6mm pushbutton and a 1.3” IPS LCD screen .It will be powered with a Li-Po battery. I have finished the schematic and the PCB design need some tweak. so follow along my project even thought there are other project that I haven’t finished but I have submitted Blare Phone Locker for funding so also follow that project too!
