Wsg girly pops i finished the macropad. twas really just alligning the connectors, making a bus that they all connect on and wiring it up. literally free ngl. wait i forgor screw holes one sec chat.
Argh probably lapse inslaytion but i did work for 2 hours on first of all adding in screw holes to the board and had to redo some of the wiring. After finishing that, I started working on the macropad. I used a chip that converts GPIO to I2C, and did all the wiring. I also figured out all the footprints and imported them. I also started on the design, lots of stuff so lots of screenshots.
Ok so the first 2 and a half hours r lapse inflation(go figure), but i basically finished the pcb by wiring everything and adding in pcb padding. twas very annoying
i think there may be a bit of lapse time inflation, but I worked on positioning the footprints. my inner perfectionist came out and i am trying to make these things precise as two ffs
Hi Cat
My kicad crashed and I had to redo the schematic and update it with correct battery wiring. I started working on the footprint and just getting general meaasurements for how it will work. I also had to import in the pogo pins and figure out which ones to use. Pogo pins are so good and really cool and r perfect for this project.
Bye Dog
So I started making the core module, i didnt have any pins, but i set up the project directory and added in le xiao after doing a bit of looking into which one to use. I also did an hour of asking people what connectors i should use and i decided on using 4 pin pogos. cant log research tho :(
