Made the case for the Macropad! The top piece gave me some problems for a while because the plate I generated for it was way too small too fit, so i had to manually measure everything in KiCad to get it all fitting nice. After this, I just need to write some code for it and then I can finally put it all together!
Finished designing the PCB for my macropad. It is going to have six buttons, one for each direction then two extra, and a rotary controller for volume. Let me know if anything should be changed!
My Hackpad
I just finished the PCB steps for the macropad but I’m not sure if everything is correct, so if you have any criticism or ideas for me, feel free to send them! Also, there are more wires on the backside as well as diodes, but I couldn’t post two images on one devlog
