Six Button Macropad
Hardware
By
@Nico
- 2 Devlogs
- 5 Total hours
A nice and simple Macropad with six buttons and a rotary encoder
4h 35m 3s logged
Made the case for the Macropad! The top piece gave me some problems for a while because the plate I generated for it was way too small too fit, so i had to manually measure everything in KiCad to get it all fitting nice. After this, I just need to write some code for it and then I can finally put it all together!
17m 51s logged
Finished designing the PCB for my macropad. It is going to have six buttons, one for each direction then two extra, and a rotary controller for volume. Let me know if anything should be changed!
