Devlog 7

I finally figured out headers, was really embarassing before. Also I started wiring up the battery charger, and am close to finishing that, and will probably start the 3.3v line afterwards.

H1 Devlog 6

I worked more on the pcb, and added the large ground plane and did some planning. The ground plane will be on layer 2, while the power plane will be on layer 3. I also learned how to use vias to supplement my smd based design.

H1 Devlog 5

I assigned all the footprints to each symbol, and finally got started on the PCB. This is definitely my hardest project to date, and am working towards finishing this! I have barely wired up the PCB, only the USB protector so far.

H1 Devlog 4:

FINALLY I am almost done with this schematic. I still have the whole PCB design left after this, and I am very inexperienced. Wish me luck!

H1 Devlog #3

So I finished wiring up this battery charger on this flight computer. Because I am using all LCSC parts, it looks like a mess, plan to clean up near the end of this.

H1 Sol Mk. I Devlog 2

Had to restart the schematic design as it was using some of the wrong components, and used LCSC components for resistors and capacitors, so when ordering parts, it becomes much easier to do so. I started wiring up the battery charger and wired up the USB shield as well.

Started PCB cad for the flight computer. So far, power distribution from USBC port is confirmed.

I finished 3d printing the fin can, and am finally done, getting ready to ship. probably my last entry.

Sooo I simulated the fin shape, and tried to fix the fin can. Regrettably, was not able to fix the fin can yet, but the fin shape seemed perfectly fine in simulation

Mostly done with the fin can. I am facing a problem with fillets, as they will not apply for some reason. I will be troubleshooting the problem for a while.

Finished Macropad Firmware, and Preparing to Figure out how to get parts!

I finished my CAD models, now time for the firmware…

Finished the PCB, and have started cadding the Case!

Finished fixing schematic, and started working on updated PCB

Messed up my PCB, the power port was facing the wrong, way, so I decided to scrap and redo the entire thing!

Finished the PCB for my macro pad! I am still struggling with the dimensions of the objects, and may need to adjust the PCB.

Just finished the pcb for my project. I am also starting work on a more complex one and am looking at files to learn how to do so.

Finished my PCB schematic!!