Aerodynamic stabilizing fin can
Hardware
By
@aaravw2001
- 3 Devlogs
- 10 Total hours
A fin can, for a rocket. Must be very sturdy, and aerodynamic.
Ship #1
Pending review
@aaravw2001
on
Aerodynamic stabilizing fin can
I made an aerodynamic fin can! I plan to use this one later and instead print it again in PA12-CF. This is also my first ship, and first thing that I designed that I have also 3d printed! In retrospect, I think making the fins bigger would have been a good idea, but in open rocket(the rocket simulation software) it showed that the design should be fine, so I guess it is!
@aaravw2001
on
Aerodynamic stabilizing fin can
8h 33m logged
I finished 3d printing the fin can, and am finally done, getting ready to ship. probably my last entry.
@aaravw2001
on
Aerodynamic stabilizing fin can
1h 4m 1s logged
Sooo I simulated the fin shape, and tried to fix the fin can. Regrettably, was not able to fix the fin can yet, but the fin shape seemed perfectly fine in simulation
@aaravw2001
on
Aerodynamic stabilizing fin can
42m logged
Mostly done with the fin can. I am facing a problem with fillets, as they will not apply for some reason. I will be troubleshooting the problem for a while.
