OptiLogic-16 Pro
I created a 16-channel high-speed logic analyzer and network monitor entirely from scratch starting from the PCB design and component selection to the FPGA firmware and 3D modeling.
How this was made
I designed an 8-layer PCB that has 16 digital inputs united by 4 comparators. The board runs with 12V DC current with a standard barrel jack connector:
- 16 analog thresholds programmable from -2.0V to +5.0V.
- A 4 Gbit DDR3 memory dedicated to sample buffering.
- Three SFP cages for fiber optic (2 are recive only and 1 is recive and trasmit).
- Gigabit Ethernet.
- USB 3.0 for PC communication.
The PCB has a precise layer structure:
-
F.Cu is only used for local connections or high speed and GND plane
-
In1.Cu is used as GND plane to remove noise and interferences from the under and above layer. It is used to put traces on it if there is no space between them
-
In2.Cu is used for short range high speed comunication like the RAM
-
In3.Cu is used only to carry power with very thick copper traces
-
In4.Cu is the same as In1.Cu
-
In5.Cu used to connect the comparators and DACs between them and wire them to the FGPA
-
In6.Cu is the same as In3.Cu
-
B.Cu used as auxiliary short distance traces
External connections breakdown
-
12V Power: The main barrel jack socket that powers the board portectd by a resettable fuse. The 12V input is stepped down with multiple converters and the 12V input becomes +7.0V, -3.0V, +3.3V, +2.5V, +1.8V, +1.5V, +1.2V, +1.0V required by the FPGA, comparators, and transceivers.
-
USB-C Port: This port supports PC communication.
-
Logic Probes: Two 20-pin headers handling the 16 high-speed input channels. The even pins are connected to GND.
-
JTAG: A 14-pin socket used to debug and flash the FPGA and the QSPI memory.
Mechanical design and why I chose certain components
To make sure the logic analyzer can sample at 500 MSa/s without struggling with signal integrity, I had to select specialized components:
-
FPGA (Xilinx Kintex-7 XC7K70T-2FBG676I): I choose the FBG676 package because it provides enough I/O pins to drive everything that is on the board.
-
Comparators (LMH7324): Selected for their 700 ps rise/fall times. By powering their output stage (
VCCO) at +2.5V, the RSPECL outputs naturally shift to LVDS levels, allowing direct connection to the FPGA without complex external resistor networks.
-
USB Bridge (FTDI FT601Q): I avoided using a PCIe interface or a complex FPGA-based USB PHY. The FT601Q provides a 32-bit synchronous 245 FIFO interface running at 100 MHz, easily sustaining ~380 MB/s of real-world bandwidth to the host PC.
-
DACs (TI DAC8568): Chosen to provide 16 independent threshold voltages. A single SPI bus configures both chips, and precision Op-Amps scale the 0–2.5V output to the required -2.0V to +5.0V range.