You are browsing as a guest. Sign up (or log in) to start making projects!

17h 19m 22s logged

OptiLogic-16 Pro

I created a 16-channel high-speed logic analyzer and network monitor entirely from scratch starting from the PCB design and component selection to the FPGA firmware and 3D modeling.

How this was made

I designed an 8-layer PCB that has 16 digital inputs united by 4 comparators. The board runs with 12V DC current with a standard barrel jack connector:

  1. 16 analog thresholds programmable from -2.0V to +5.0V.
  2. A 4 Gbit DDR3 memory dedicated to sample buffering.
  3. Three SFP cages for fiber optic (2 are recive only and 1 is recive and trasmit).
  4. Gigabit Ethernet.
  5. USB 3.0 for PC communication.

The PCB has a precise layer structure:

  1. F.Cu is only used for local connections or high speed and GND plane
  2. In1.Cu is used as GND plane to remove noise and interferences from the under and above layer. It is used to put traces on it if there is no space between them
  3. In2.Cu is used for short range high speed comunication like the RAM
  4. In3.Cu is used only to carry power with very thick copper traces
  5. In4.Cu is the same as In1.Cu
  6. In5.Cu used to connect the comparators and DACs between them and wire them to the FGPA
  7. In6.Cu is the same as In3.Cu
  8. B.Cu used as auxiliary short distance traces

External connections breakdown

  1. 12V Power: The main barrel jack socket that powers the board portectd by a resettable fuse. The 12V input is stepped down with multiple converters and the 12V input becomes +7.0V, -3.0V, +3.3V, +2.5V, +1.8V, +1.5V, +1.2V, +1.0V required by the FPGA, comparators, and transceivers.
  2. USB-C Port: This port supports PC communication.
  3. Logic Probes: Two 20-pin headers handling the 16 high-speed input channels. The even pins are connected to GND.
  4. JTAG: A 14-pin socket used to debug and flash the FPGA and the QSPI memory.

Mechanical design and why I chose certain components

To make sure the logic analyzer can sample at 500 MSa/s without struggling with signal integrity, I had to select specialized components:

  • FPGA (Xilinx Kintex-7 XC7K70T-2FBG676I): I choose the FBG676 package because it provides enough I/O pins to drive everything that is on the board.
  • Comparators (LMH7324): Selected for their 700 ps rise/fall times. By powering their output stage (VCCO) at +2.5V, the RSPECL outputs naturally shift to LVDS levels, allowing direct connection to the FPGA without complex external resistor networks.
  • USB Bridge (FTDI FT601Q): I avoided using a PCIe interface or a complex FPGA-based USB PHY. The FT601Q provides a 32-bit synchronous 245 FIFO interface running at 100 MHz, easily sustaining ~380 MB/s of real-world bandwidth to the host PC.
  • DACs (TI DAC8568): Chosen to provide 16 independent threshold voltages. A single SPI bus configures both chips, and precision Op-Amps scale the 0–2.5V output to the required -2.0V to +5.0V range.
0
30

Comments 0

No comments yet. Be the first!