You are browsing as a guest. Sign up (or log in) to start making projects!

cyberpunk clock

Hardware
  • 1 Devlogs
  • 0 Total hours
Open comments for this post

23m 3s logged

Devlog 1: Schematic & PCB Layout for the Cyberpunk Alarm Clock! 🛠️⏰, Today I officially kicked off my BLARE alarm clock mission for StarDance! I decided on a Cyberpunk-inspired aesthetic: an alarm clock featuring a Seeed Studio XIAO ESP32-C3, 4 mechanical keyboard switches for tactile controls (Hour, Minute, Snooze, Mode), a piezo buzzer for custom chiptune alarm melodies, and an 8-pin header for the 2.25” TFT screen.

What I completed in this session:

  1. KiCad Setup & Library Config: Set up KiCad 10 and configured the Seeed Studio XIAO ESP32-C3 symbol and footprint libraries.
  2. Schematic Design: Placed and wired all components in the schematic editor. Used clean net labels for all signals (SW_HOUR, SW_MIN, SW_SNOOZE, SW_MODE, BUZZER, TFT_SCL, TFT_SDA, TFT_DC, TFT_CS). Mapped RST to 3.3V and BL to GND as recommended in the BLARE guide to save GPIOs. Ran ERC with 0 critical errors!
  3. PCB Layout & Outline: Transferred components to the PCB editor and drew a clean 95mm x 55mm board outline on the Edge.Cuts layer (well under JLCPCB’s 100mm limit).
  4. Component Placement: Aligned the 4 MX mechanical switches in a row with standard 19.05mm spacing for keycap clearance. Placed 4 M3 mounting holes in the corners for the 3D case, and flipped the ESP32-C3 and piezo buzzer to the back layer (B.Cu) so they will be neatly hidden inside the enclosure.
  5. 3D Inspection: Checked out the board in KiCad’s 3D viewer, and it looks super clean!
    Next up: Routing all copper traces on F.Cu/B.Cu, pouring the ground plane, and starting the 3D case design in CAD!
1
0
44

Delete project?

Are you sure you want to permanently delete this project? This action cannot be undone.

All devlogs, followers, and associated data will be removed.

Followers

Loading…