sorry I'm moving these
Hardware- 9 Devlogs
- 13 Total hours
I’m moving my projects to fabricate :(
I’m moving my projects to fabricate :(
this is version 4! version 5 had one less gear segment & doesn’t have the last gear, and v6 be will the final prod model if v5 works
OK SO friction is a huge problem, bearings staying in place is a problem, gluing stuff together with gel cyanoacrylate is a huge problem.
This is going to take longer than I thought lol.
Namely, I have to rethink the design,, along with backdriving a DC motor anyway.
But it worked a couple times, temporarily.
hopefully that works, had to hunt down the datasheet from this obscure aliexpress product
there’s nothing wrong with v2 theoretically, but I made a v3 that would make it more compact and fit better with small bearings. so here’s v3!
nicer looking gears!
Good 5AM everybody :>
Here’s a schematic!
.
Since DC motors are gonna output anywhere from -9V to 9V depending on how fast/how we crank the dynamo, we’ll need something to turn it into a stable 5V in a USB-C.
.
This uses a full bridge rectifier (schottky diodes) to make the voltage positive. The amperage of this generated voltage is super low, so the UPS module will use it to power a battery, which then trickles high amp voltage into the phone.
This is a dynamo, for backdriving a DC motor to produce a voltage across both ends. The purpose, ultimately, is to be able to convert it into a stable 5V at enough amps to charge a phone.
First we’d have to get the motor spinning though, at about 8300 RPM / 60 = 138 RPS. I thought about using a gear train to backdrive it but there seems to be too much friction, so I’m using a wheel and rubber band system.
The ratio is about 6:1 *8:1, for a total of 48:1. So hopefully brisk spins would work? Otherwise, we would just need one really big sprocket.