this is version 4! version 5 had one less gear segment & doesn’t have the last gear, and v6 be will the final prod model if v5 works
this is version 4! version 5 had one less gear segment & doesn’t have the last gear, and v6 be will the final prod model if v5 works
OK SO friction is a huge problem, bearings staying in place is a problem, gluing stuff together with gel cyanoacrylate is a huge problem.
This is going to take longer than I thought lol.
Namely, I have to rethink the design,, along with backdriving a DC motor anyway.
But it worked a couple times, temporarily.
hopefully that works, had to hunt down the datasheet from this obscure aliexpress product
there’s nothing wrong with v2 theoretically, but I made a v3 that would make it more compact and fit better with small bearings. so here’s v3!
nicer looking gears!
pcb didn’t work because of some mystery reason that I’m going to figure out later, but battery would only turn the backlight on, and the code wouldn’t turn the backlight on, even explicitly setting the pin to high.
I made my final bugfixes and a few optimizations for web, I think you guys will really enjoy the game!
Good 5AM everybody :>
Here’s a schematic!
.
Since DC motors are gonna output anywhere from -9V to 9V depending on how fast/how we crank the dynamo, we’ll need something to turn it into a stable 5V in a USB-C.
.
This uses a full bridge rectifier (schottky diodes) to make the voltage positive. The amperage of this generated voltage is super low, so the UPS module will use it to power a battery, which then trickles high amp voltage into the phone.
This is a dynamo, for backdriving a DC motor to produce a voltage across both ends. The purpose, ultimately, is to be able to convert it into a stable 5V at enough amps to charge a phone.
First we’d have to get the motor spinning though, at about 8300 RPM / 60 = 138 RPS. I thought about using a gear train to backdrive it but there seems to be too much friction, so I’m using a wheel and rubber band system.
The ratio is about 6:1 *8:1, for a total of 48:1. So hopefully brisk spins would work? Otherwise, we would just need one really big sprocket.
Also check out this e-ink thingy, I was gonna use it for this project but it didn’t fit the use case very well. Dunno what I’ll use it for in the future. Code credits to blurPP/ssd1681_epaper_driver_micropython !! for the demo
Somehow we’re starting at 52 hours, probably more since I fiddled with it for a really long time while trying to learn microelectronics..
Anyway, since I joined this pretty late with this project, honestly the software part is mostly finished. I spent the last month
So this week I made some games!
They use two buttons, since the main page navigation and UI of the environment sensor uses two buttons.
It runs on a TFT LCD!!! But for ease of testing, I have a True/False flag in the code that runs it through pygame (adafruit_displayio_blinka library, I think) so I can simulate and test on the computer. Pretty neat