Camera circuit bent

Ship #1 Pending review

@Anastt on Camera circuit bent · about 3 hours ago

I circuit bent a kids camera without the soldering part. Would solder it but i dont have a soldering iron btw. Really fun project overall, liked doing it. I only used a wire, lots of tape and a piece of a kitchen sponge to apply more pressure. You can get many different coloring effects that react to the lighting detected. Also it took more like 3 hours, read my 1st devlog for that. It wasnt too hard tho, im a complete beginner in hardware stuff and i managed ^^

1 devlog
2h build

Video of Project → See source code →

Open comments for this post

@Anastt on Camera circuit bent · about 4 hours ago

1h 40m 25s logged

Solderless camera citcuit bend –– (this project actually took about 3 hours, i just couldn’t record it with lapse right away cz i dont have a webcam, i had to record on my phone and send it over but it run out of battery mid recording) This was a very fun hardware project. I basically used some copper wire to do the bend, couldnt solder it cz i dont have a soldering iron. The result is the same tho!! And its a reversible thing too. This was done on a very cheap kids camera i got 2nd hand, so i didnt really worry about breaking any components. Also i ended up cutting up and using a piece of a sponge to apply even pressure on the wire cz the tape wasnt enough. Thats it thx byee ^^ (side note, pics say 2019 cz i coulnt change the date in the settings)