Solderless camera citcuit bend –– (this project actually took about 3 hours, i just couldn’t record it with lapse right away cz i dont have a webcam, i had to record on my phone and send it over but it run out of battery mid recording) This was a very fun hardware project. I basically used some copper wire to do the bend, couldnt solder it cz i dont have a soldering iron. The result is the same tho!! And its a reversible thing too. This was done on a very cheap kids camera i got 2nd hand, so i didnt really worry about breaking any components. Also i ended up cutting up and using a piece of a sponge to apply even pressure on the wire cz the tape wasnt enough. Thats it thx byee ^^ (side note, pics say 2019 cz i coulnt change the date in the settings)