67% keyboard

I redesigned the case so that I cna connect both sides and because it would not fit in my printer. On the image it basically looks the same. I deleted some of the switches because they made it laggier

finished a very basic case for my keyboard:

Unfortunately I realized it too late, and as I was designing the 3d case, I saw that the LED’s were on the wrong side of the pcb. It took like 3 hours to wire those so I decided to just completely get rid of the LED’s, then just re trace everything. It looks like 10x better now:

Finished checking the DRC and adding 3d models to the 3d viewer to export.

I official finished creating all of the traces on the PCB. It looks really messy and its because I didn’t really pay attention to how it looked, instead I just focused on finishing it and just working. there was around 350 traces so it would take way too long if I wanted it to look good.

I have put all of the schematics into kicad PCB, then positioned them into their designated spots. Finally, I assigned 3d models to all of them(except OLED and rotary encoders)

I finished working on the keyboard schematic with 74 keys, 2 rotary encoders, a 0.91 inch oled and led’s.