SnowPad
Hardware- 4 Devlogs
- 20 Total hours
I am building a 3x4 macropad, with rgb light and oled display.
Entry #4
-I am finally done with the PCB and the CAD for the pad
-I tried creating the code for the pad. I first tried using QMK, which proved really difficult since there is no keyboard layout that matches my board
-Now I am switching to KMK, but KMK through the POG configurator requires a board with CircuitPython, which I currently don’t have
Entry #3
I have continued my work on the macro pad, in these hours I have redone the wiring for the pcb as I had not used the copper pour for gnd, now the wiring is not that messy
I have also started on my case on fusion 360
Entry #2
I have finished the pcb
Entry #1
I have made the schematic for my hackpad. I have come to a setup with a 4 by 3 switch matrix, RGB light, OLED display and a rotary encoder. This setup uses the max GPIO available on the Xiao, now onto the PCB
