Basic Page Turner

Today I did the CAD for the enclosure of the Page Turner. All I have left to do is prep the files, finish the repo, and get cost estimates for all the parts! The case is structured to properly support the pcb over the battery and expose needed components.

So today I made the firmware. You can swap between 4 different keymaps, repair BLE, turn the pages, and it even has a status LED that will display the current mode or pairing status. Now I just have to do the CAD and budgeting. Here’s a picture of the Schematic since a picture of code you can’t see all of unless you check the repo wouldn’t be that helpful.

This is going to be a pretty short project, since it’s a fairly simple item. This is devlog 1 of 3-4 for the pre-funding part. I’m making a page-turner pedal with BLE. So it connects to the device you are using for sheet music, and when you press one of the buttons, it will turn the page. For this section, I made both the schematic and the PCB layout.