A led matrix
Devlog 1:
*choosing parts
^designing the circuit
~parts wont fit on the pcb
- I wanted to build this from scratch so instead of using a driver board I’m using 8 shift-registers linked together. The first one gets the input from a buffer to keep the input from degrading. I didn’t use any transistors arrays because i thought 5mA for a single led would be enough. So the parts are as follows:
- 8x 74HC595
- 1x 74HC244
- 64x 5mm LED(standard THT)
- 64x 560 ohm THT resistors (1/8W)
- 9x 10nf decopling caps (ceramic)
- 32x 10k THT resistors pull-__ (1/8W)
^The circuit desing was relatively easy. I just connected the components on kicad editor. But first time using it so there are some naming issues and the whole circuit doesn’t quite fit on the A4. Footprints were from the standard library.
~ Currently designing the pcb (at least trying to). I’m having problems trying to align every single component by hand since there is a lot of them. And I wasn’t able to fit the buffer on the size I wanted the pcb to be. (I can always put it vertically thought).
Even then I want to have a common potential plane witht the 5V on the side of the LEDs but after putting all the components there doesnt look like it will have much effect. Other than the main power lines carrying 5V at 2.8A looks hard to fit ( if its even possible). So I might go for 2 seperate pcbs.
Comments 0
No comments yet. Be the first!
Sign in to join the conversation.