Devlog #6 Hello everyone! Today I want to explain something about the phone section. The lid that is disconnected from the phone locker will be connected to the servo, so the servo can open it and close it. Then, the wire of the servo will go under the support and throught the hole and connected to the PCB. Finally, the phone locker section is connected to the alarm section. This means the alarm section and the phone locker section will be printed together but if the 3D printer printing margins is to small, the alarm section and the locker section will be printed separatedly and be glued by using a 3D pen but it will not looked as good. so that is all from me and also follow along my other projects.