ESP-CAR

Created a better differential housing and gears. Upgraded all bevel gears to be smaller and structurally stronger. I also modalized the differential to create a easier assembly. Also changed the design plans to include ball bearings.

Created a Rack and Pinion for the steering. I also created the code that will be used for this project. I also fixed my github, adding folders, every file, the BOM, and including a note for stardance and hack club

I created the mid section of my car/rover in Onshape. it will contain the BLDC motor that will be the engine for the car/rover. It will also connect to the rear are forward sections of the vehicle. I also included a easter egg in the build, which is the text on the part, see if you can decode it!!! (The text is visible in the picture below btw)

I created the rear section of my car that will contain the diffriental and the differential drive system. This took a stupid amount of time on Onshape

I created the housing for the differential. Inside of the 3 holes there will be a bevel gear in each to create a differential. This thing is very beautiful right?

Today I started a new project called ESP-CAR. it will be a Car like a RC car but it will run with ESPNOW. I plan to use almost every mechanical system inside of a real car into this small rover/car thingy. Today i created the Bevel gear that will be one of 3 inside of the differential that will control the rear wheels.