Devlog 2 | Hello or should i say goodbye 😭 stardancers. In this devlog i want to present to you…. THE GREATEST…. THE BEST MACROPAD you will ever see. OK ok , if being serious there is nothing impresive with scapad . I would want to say that everything went according to my plan , but sadly because of my inability to wait and be careful i made a fatal mistake that almost made me give up when i was assembeling the board , the error was that i soldered the microcontroller the wrong way and the buttons weren’t connect to the gnd at first i attached external wires , but it seemed too ungly , so i just attached another pcb(the same design) near it that works and connected them with small wires and now the macropad works , but … it became bigger and it doesn’t fit in the case i had prepered and my 3d printer is not working 😭. So here is just the pcb in the jlcpcb box.I will be sumbitting this project so please wish me luck!!!!