My awesome macropad!
Hardware
By
@jchuan
- 9 Devlogs
- 8 Total hours
Macropad with 8 keys
@jchuan
on
My awesome macropad!
28m 2s logged
Finished Repository,ready for submission
@jchuan
on
My awesome macropad!
31m 1s logged
improving circuit more
@jchuan
on
My awesome macropad!
18m 1s logged
Just reworked circuit lines so its not 90 degrees for any, slacking on this project due to Engineering studies assessment study
@jchuan
on
My awesome macropad!
22m 1s logged
drc retest
@jchuan
on
My awesome macropad!
35m logged
upgraded bits also measured design
@jchuan
on
My awesome macropad!
1h 54m logged
Finished CAD and PCB done yesterday all that is left is github and then i can ship
@jchuan
on
My awesome macropad!
36m 7s logged
Updated version of macropad, switched it up and somehow managed to add 5 more switches and also implemented diodes
@jchuan
on
My awesome macropad!
2h 0m 12s logged
Macropad update My initial design itself became too complex so I decided to follow the guide except the esp32 seedstudio component didnt fit so i just put it at the top and the pcb works, no errors appeared after DRC test, now its just using fusion before this project is complete
@jchuan
on
My awesome macropad!
1h 30m 1s logged
This is an incomplete version of my PCB for the Macropad which i intend to complete. It features 9 key switches currently and a 0.91 inch oled display. I used kicad to first add all the key switches then connected them to dedicated pins and then connected the other side to Ground pin, after that I worked on the oled which again was just connecting them to pin. After this step I converted into PCB editor and I’m yet to connect them together
