@jchuan

Debugging

Just worked on trying to rewire because it overlaps

Done alot of engi, did some of this but to be honest, im kind of confused now because when uploaded pcb design to jlcpcb just to look, it is so cooked

Blare alarm just fixing pcb lines, photo below is just my engineering studies work to cover left which is why i havent been doing much work on stardance

Started on Project pcb is finished however when i turned into zip and tested it by placing it on jlcpcb to see if it looked right, it didnt have copper

Finished Repository,ready for submission

improving circuit more

Just reworked circuit lines so its not 90 degrees for any, slacking on this project due to Engineering studies assessment study

drc retest

upgraded bits also measured design

Finished CAD and PCB done yesterday all that is left is github and then i can ship

Updated version of macropad, switched it up and somehow managed to add 5 more switches and also implemented diodes

Macropad update My initial design itself became too complex so I decided to follow the guide except the esp32 seedstudio component didnt fit so i just put it at the top and the pcb works, no errors appeared after DRC test, now its just using fusion before this project is complete

This is an incomplete version of my PCB for the Macropad which i intend to complete. It features 9 key switches currently and a 0.91 inch oled display. I used kicad to first add all the key switches then connected them to dedicated pins and then connected the other side to Ground pin, after that I worked on the oled which again was just connecting them to pin. After this step I converted into PCB editor and I’m yet to connect them together