Finished 3d printing the components. stator and cap turned out beautiful while the casing was a little sketchy but still will do the job. Had to sand off part of the supports because they had melted into the bottom layer of the casing on one side. I am going to have to scrap the spacer because my screws are not long enough but i do have these little extension peices that give enough room to hold the bottom cap and then nuts and washers on the bottom to secure the assembly. I stuck with the original design for the stator because im worried about overheating or loading too much weight on the outside of the print. I printed all of these in abs for maximum strength and heat resistance. All parts were printed at 20% infill except the stator with 60% to make sure an arm does not snap off. Next step will be wrapping the coils and final assembly.