Design2.1 and started 3d printing. Question do you guys think that the inital design that im printing or the updated version of the stator (part that holds coils) will be more efficent? I think the new version will be better becuase it puts more copper and material closer to the magnets to get a stronger push. However as i showed I allready started printing and am reluctant to shift so quickly. Other minor updates: Separated spacer and bottom “cap” to 3d print eaiser because i wanted an encave on the bottom to thread the wires through to give a more polished look. The orange circle is to connect to the bottom if I want to attach it to something later. Im 3d printing in abs to have more heat resistance than pla and to be a bit stronger.