PCB Routing and Completion of the Final Project

Today, I have completed the final step in my PCB design project PCB routing and finalization.

First of all, I had to choose the PCB layer stack-up. At first, I wanted to use fewer layers; however, considering that the components were distributed across the whole board and the routing was getting too complicated, I decided to use an 8-layer PCB. The 6-layer PCB was not enough to route everything well. I made the required configuration of outer and inner layers in order to have enough space for routing and connections.

After the layer stack up configuration, I proceeded with PCB routing and connecting all the components. This step became one of the most crucial steps of the project since all the connections should be made according to the design rules and be correct.

When I routed and connected the components, I proceeded to the DRC and corrected all the errors that I received during the check.

After correcting the errors, I made the last adjustments to the PCB, adding graphics and visual elements.

Now the PCB design is complete.

Status: Project Completed