Today’s Progress

After completing the B2-STEALTH-FC project, I continued with the rest of the schematic and PCB designs. Since this project has been ongoing for some time now, today was all about connecting the remaining sections and preparing the design for the PCB phase.

I finished connecting the rest of the connectors such as the UART, ESC, final connectors, among others. I also included the mounting holes and finished the GYRO sensor section as well as the supporting connectors.

Once the schematic was done, I proceeded to create the PCB. I imported the schematic onto the PCB and started laying out the components and connections. I defined the board outline and the major board sections such as the USB-C interface and other critical sections.

The main structure of the board is done and the PCB design looks more like the actual flight controller PCB.

Today’s Work
Finished the remaining schematic connections.
Included the UART connector.
Connected the ESC.
Connected the rest of the interfaces.
Mounted the holes.
Included the GYRO sensor section.
Completed the supporting connectors.
Imported the schematic into the PCB layout.
Laid out the components and connections.
Included the USB-C interface and started defining the board outline.

Status: Schematic done and PCB layout started.
Next: Finish the PCB layout.