Finished designing my Hackpad case in Fusion 360!! 🎉This part was honestly a STRUGGLE 😭 I ran into a lot of problems with the switch plate, alignment, sizing, clearances, and getting everything to actually fit inside the case. I had to redo and adjust things multiple times, especially the switch plate, but I eventually got everything lined up correctly.I made the bottom case and switch plate, added the cutouts for my 10 switches + OLED, and customized the case with my own engraved designs.After all the fixing and adjusting, I ran an interference check and finally got no interference!! 🥳Definitely one of the harder parts of my Hackpad so far, but I learned a lot about Fusion 360, sketches, extrusions, dimensions, clearances, and troubleshooting when something doesn’t work the first time