my hackpad (im seriously not good w names)

heyy
so i really don’t know what i was thinking when i started this project, but it’s not going easy. but i like challenges.
so i designed my pcb and my case using kicad and fusion 360, and thinking that i have never used both of the platforms before it was HARD. the guide is always good but i wish it would’ve been a little more clear on the instructions this time. anyways i am kind of scared of what’s next but i hope that i can manage it - and i really hope that i didn’t make a huge mistake i can’t change until now i really can’t tell if everything is right…