Hey guys! This is my first devlog for the Tabla powder sensor. More about it in the bio of this project.

Here’s what I got done:

Just started on the code for the temperature sensor. trying to get it set up so it could also be interpreted into commands that the servo can use.

Am using the DHT 11 sensor for anyone curious.

Am also going to be using an Arduino Uno R3 for the microcontroller, so I will be inputting this code to Arduino IDE once I get that setup with Hackatime

Started off by creating a function to just start checking whether the readings from the sensor are not toofat and are reasonable. Having a little trouble with pointers, but did get it figured out after watching a few videos.

The code timing looks short because I started halfway in the same folder that contained another project before I figured it out.