Fpv mini rc car

Today I was soldering the electronics and putting everything together. Code is working well and the next step is to design wheels.

I started assembling the RC car and also designed a cover for electronics.

I just finished modeling placeholders for electronics.

I didn’t save my files last time, so today I had to remake everything I did last time.

I almost finished working on the chassis for my RC car. The next step is to make mounts for the rest of the electronics.

Hello! Today I finished designing and printing the gears for both the motor and the axle. I also tested different gear ratios and found the best balance between speed and torque.

I made the RC car wider to fit the electronics, so I widened the front chassis and improved servo mount.

I almost finished the steering system for the RC car. The only thing left to make is the placing for servo motor.

Today I was still working on the steering system of my car, and I hope I will finish next time.

Today I started working on steering system of my car. I had to design the spindles for the steering system.

Started the RC car rear chassis today! It doesn’t look like much yet, but I made space for the motor and shaft. Next time, I will add gears and finish the back hopefully.