Finished the PCB

The final coat of copper pavement was carefully laid out as the green city was unified at last.

Changes

I routed the motor driver’s pins to the two 6-pin adapters on the bottom right of the board. I connected the last pads, and added some finishing touches such as screw holes for a 3D-printed enclosure and some custom silkscreen cuz why not. I also filleted the edges as I read that it was a good practice online.

What’s Next?

All of the GND pads are isolated, so I need to make a copper fill zone or something to link all of them. I also plan on adding a little silkscreen on the back, and then we should be good to go!