Standoff Redesign

The old standoffs had an issue because they weren’t properly threaded, which meant that there really wasn’t much aside from minimal friction that was holding the screws in place.

The Fix

I redesigned the standoffs by making them wider, thoroughly hollow, and exposed on one half. This allowed me to slide nuts and screws inside the standoffs, which will guarantee a perfect lock. Another issue that this redesign fixed was the blocked hole problem. Essentially, when I put a screw in a hole on the middle chassis, I couldn’t then use that same hole for another standoff to connect the other side. This solves that issue since a single screw on the middle chassis can now go through two standoffs at once, allowing me to connect both sides.