Since my last devlog, I realized that I connected part of the keyboard matrix to the 3.3v output pin, so I had to update the PCB once again (and remove one of the keys since I didn’t have enough pins…again). The PCB is finally completely finished!! I also have a good chunk of the CAD for the case done :).

For the case I have 3 printed layers, the bottom that holds the PCB, a middle diffusion layer for the LEDs (just a very thin layer of white PLA that I hope will look nice), and the top layer to make sure everything can be assembled easily.

Up next: add finishing touches to the case, add mounting hardware/interface, introduce myself to QMK for the firmware.