Arduino LED heart display
Hardware- 3 Devlogs
- 5 Total hours
Using LED on a breadboard to create a heart. It will have different modes such as, on, blinking, flashing each colour, etc!!
#DevLog_3 Working on the hardware elements. Putting all the components on a bread board and wiring it up. Also worked on some test code, just to check that my wiring was correct and the LEDs turned on when the button was pressed
#DevLog_2 All wiring is complete!! I also added a push button so people can change that mode with a button. This also makes it interactive as it requires user input. I also worked on some code example for each mode.
#DevLog_1 I have started to figure out the wiring for the circuit. I used Tinkercad to do this. I ran into the main problem of it not all fitting onto in breadboard, and some of the LEDs didn’t light up. Also the wires look really messy, but I plant to sort that out after it all works!!
