@Chonki_29

#Devlog 9
The macropad is complete!!!
Made the custom volume knob, fixed up the colors of the Macropad and made the github repo!

#Devlog 8
worked on the firmware all left is the knob and making a github repo for it :))

Devlog 6
Got the macropad case 70% done :)))
just need to make a knob for the potentiometer and the firmware for the macropad

Devlog 5
can someone help me with this macropad project 💔💔💔💔the case designing part is too insane for me + this is my first time using fusion

Fixed the old schematic and made the pcb :))
when i first made the schematic of the circuit i used the wrong type of esp32 this time i replaced that added the correct one made the connections and then made the pcb for the circuit :))
(0 errors and 0 warnings)

PCB mounts and switch plate made!
and lower back is dead if anyone got solution for lower back pain pls tell

devlog 4-
wasted time on fusion 360 can someone recommend a better app which is beginner friendly unlike fusion 360 🫡

Devlog 3-
made some changes to the pcb like added mounting holes, made the type c stick out a bit more so its easier when doing the case, removed 1 knob because who even needs 2 knobs? and removed 1 switch because 5 are obv enough :)))))

Devlog 2
Finished the PCB of the macropad :))
first time making a pcb and first time using kicad pcb maker too made the whole pcb in under 3 hours it was fun and annoying as yesterday when i made it the app crashed and it wasnt saved and today i forgot to measure the things before placing them so had to redo the routing with proper measurements this time and added the .step 3d models so the 3d view of pcb looks sick!

Macropad devlog- started working on the schem and pcb of the macropad worked for around 2hours because learning to use kicad while making the designs and after the pcb was done (95% done just a few warnings was working on them) KiCad decided to crash 😀😀😀😀 checked local history and found no save of the pcb…

this tells us that we should spam control + s (didnt press control s a single time while making pcb)

5x5 LED Matrix design on KiCad

5x5 LED MATRIX soldered onto zero-pcb with resistors (hardware part complete)

DIY MATRIX + DIGITAL DICE COMPLETE!!!

DIY MATRIX + DIGITAL DICE COMPLETE!!!

5x5 LED MATRIX soldered onto zero-pcb with resistors (hardware part complete)

5x5 LED Matrix design on KiCad