@krisander

I fixed the slope problem but I think its gonna cause a new problem… the oled may not fit on the elevated plain. The capacitors seem like they wont fit but ill just bend it down sideways.

i got a lot of work done today, I’m getting more familiar with fusion 360. I have to fix the angle it slopes at. Its currently too low it will probably get cut off by the slider other ways.

I’m creating the 3d print now. I its sooo hard cos my laptop does not have a gpu. :-(

I think I’m finally done with the PCB, I know I said it before but the board exceeded the max board size. i had to rearrange it and also added some random silkscreen art. I have a few parts that StarDance does not provide. :-)

This is the last of the PCB editor. I ran DRC and it came back without errors and warnings.

I did a lot of work, I printed out the schem sheet and matched it with the actual dimensions and all, but the prb is I didn’t realize that the keyboard switches were too far apart… I have to delete all the wiring before shifting the keyboard switches back and then rewiring….. HELP

i fixed up the neo-pixel problem, i miss took the tiny leds for the ws2812b kind, so i fixed that and the project passed the E.R.C.

i fixed the matrix. im trying to fix the slider pin value problems. i will start the 3d modleing or coding next.

started schematics I’m thinking of adding a diode in the key matrix layout so that there is no ghosting in the hek-pad. I wont be able to do much because of my exams. I will get back on as soon as the exams are over.

i finished all the PCB Editing in about 5 hours!! I’m gonna put the PCB files on github soon. I”ll also send it for reshipping… hopefully it will be accepted.

i fixed the schematics of the board. I added switches and labeled everything. I ran through the tests and it passed perfect.

I found out i have to create a pcb so I’m doing it.

im working on aa new project called tab-tamer, as a part of frictionless. I got this cute extension called cat face on vs code that gets happier the more errors i correct!

got the project working as an extension, i will make it actualy work in the span of about 10 days, i wont be albe to do as much because of my exams.

I just dropped version 1.3 of the esp-pod on github , go check it out!

I’m currently fixing the keyboard navigation, and adding code to rename artists as well. I will update agian after fixing it.

this is a small metall detector built based on the bc547 transistor, it uses a electro magnitic coil to detect fluctuations caused by metal and amplifies the siginal into a led and buzzer.

just uploaded build montage on lapse go check it out