Devlog #3 Finished modeling the case and customizing the firmware for basic use. For the case I went with 15 degree tilt and simple design to be printed in two parts: base, and plate. Holes inside line up with the PCB’s drilled holes for alignment if needed. The back hole for usb c connection is intentionally left big for this first iteration to allow for better alignment and will be cleaned up later. A knob for the rotary encoder also needs to be made once I have the exact physical measurements I need to ensure there are no collisions. For the firmware I used QMK and customized my own keyboard and keymapings. Right now this is just basic and only accounts for the switches. The oled and rotary encoder will be added in another commit.