ForgeS3 V1
Hardware- 0 Devlogs
- 0 Total hours
Iam making a ESP32-S3 development board with USB-C, GPIO expansion, I²C/SPI/UART interfaces, battery input, and onboard power management.
Hi hi!
Great work on this project! However, it seems like the PCB that has been modelled on KiCad is missing some traces! Take a look at the image.. I would recommend running a DRC in KiCad to make sure everything is working.
Hi hi!
This project has an AI description. Please write it yourself Take a look at the attached image for the full result.. In addition to this, you have sentences like "Configure native USB options if required by the selected board package", but you have the board package they are going to use, so can't you just provide that?
We do this since humans are the ones who are going to be replicating your project, so humans should be the ones writing it!
Hi hi!
Great work, but more detail needs to be added to the README.
1. Put the best PCB image at the top
Move the strongest 3D render directly below the title so visitors immediately see what you've designed.
2. Make the technical information more specific
Explain the board's dimensions, input voltage, USB functionality, exposed GPIOs, and power architecture. Include actual values only after confirming them against the schematic and layout.
3. Add a Getting Started section
Explain how to connect the board, install the required development tools, select the ESP32-S3 target, flash a sample program, and view serial output. If firmware isn't available yet, say so explicitly.
After you make these changes, submit again, and we will take a look! :D