You are browsing as a guest. Sign up (or log in) to start making projects!

3h 24m 2s logged

10/31: Finishing PCB and case. My goals were to finish wiring the new PCB (with the larger screen and adding a battery connector) and to design a 3D printable case with cutouts for buttons at the top (to keep the depth of the case lower). I selected a 420 mAh LiPo battery because the ESP32S3 Plus’ onboard charging circuit and battery pins were designed for a LiPo battery (with the added benefit of them being thinner than Alkalines). Additionally, 420 mAh happened to be the largest size Adafruit currently has in stock with a short connector. So, I spent some time trying to optimize the battery connector placement so that it wouldn’t get stabbed by pins or conflict with other parts, and wouldn’t put too much strain on the cable. Next, I finished up the wiring and started on the case before realizing that the PCB was lopsided around the screen, so I had to shrink the height so it would look good and rewire the keyswitches (it also took an embarrassingly long amount of time for me to realize that the keyswitch footprint was incorrect which was why the 3D model wouldn’t sync up, had to go and look at an older project to realize.) Once the 2nd iteration was finished, I imported it into Onshape and designed a case (PCB held on by screw holes into the acrylic). I had to create a model of the screen I was using because there were no existing ones, and designed a top to be superglued on (in order to make it easier to put the keyswitches on top). There is a port to charge the battery of USB-C, so I shouldn’t need to open the case.

0
7

Comments 0

No comments yet. Be the first!