Basic PCB Setup: starting off as individualizing the guide for BLARE (alarm clock guided project) just to get a sense of the size I want the project to be. My goal for this project is to create a small, portable alarm clock that is more consistent than my current one, can store music as .wav files, and has some method of getting me awake more effectively (current plan is to make the only way to turn off the alarm to solve definite integrals). I finished the schematic and wired up the keyswitches, pin header, and buzzer to the esp32c3. Additionally, I finished wiring the PCB. I chose to switch to a rectangular form factor considering I would want to carry this for travel and it needs to be as thin as possible. The next steps are to adapt it to the items I currently have and decide what extra features I would like (also to add a battery) 10/30, proceeding with further customizing the alarm clock. I currently have a 2.8” TFT display that I ordered before realizing that it was the wrong size for another project, so I plan on using it (it also conveniently supports touchscreen!) The larger screen will help with displaying more info (if I want weather, etc.), has a better color range so it looks better, and also has an SD card slot if I want to store data (can also display and store more math problems!). The TFT does however have 18 pins (14 for the display and 4 for the SD card), which the ESP32C3 I was using cannot handle. So, I switched to a ESP32S3 Plus because it has more pins, and decided to drop the 5 pins for the touchscreen so I could wire it to the ESP32. With regards to form factor, the case will only be slightly larger than the screen, and the buttons are either going to be mounted on the back or on the top of the case (the latter requires wires to be soldered to the board, which could come out after much jostling and bumping). Tasks completed: switching out the ESP32C3 for a ESP32S3, rewiring schematic to new MCU and adding 14 pin and 4 pin header for the new display, redesigning board and moving around components, and rewiring PCB. I switched to 3 buttons instead of four due to space constraints (currently planning on soldering wires to buttons on the top of the case). To do: need to write some basic firmware, add in a battery/power solution, and make a case.
Comments 0
No comments yet. Be the first!
Sign in to join the conversation.