You are browsing as a guest. Sign up (or log in) to start making projects!

@Lxsh-S on Pacpad

1h 42m 10s logged

DESIGN PHASE #5
Lol :)
I changed the design one more time :yayayayayay-67-67: :yayayayayay-67-67:

Progress

  • I tried changing the design of the top case to look like a wave from the side and ig it resembles it a little
  • Also I added much needed curves to the design :freaky:

I’ll provide the screenshots but also checkout the guithub page!! :)

1
297

Comments 6

@gismondi_simone

Cool design, though I have some doubts about how well the 3D printer can print the blue part, due to the strange curve on the Z-axis

@Lxsh-S

Was wondering the same @gismondi_simone
Do you have any work around? I thought it’ll be fine

@Tensor

as long as there isn’t a 45 degree cliff it should be fine. the layer lines will be a bit more visable tho

@Lxsh-S

Alright thanks @Tensor , Uk I had been looking at your projects : P
So ig there shouldn’t be any big issues here am I right?

@Tensor

That overhang on the charging port hole looks very thin and it could ruin your print if there are no supports. You could just remove it since it’s much easier that way. Good luck with your project.

@Lxsh-S

Okay thanks!