FINISHED Rev 1B

I finished this revision by adding a few things:

A full changelog bellow

Rounded corners (idk just looks better in my opionion)
Changed the TVS blows a fuse thing for a diode for proper reverse polarity protection
Rearranged all the components
Fixed some decoupling caps that were linked to GND and 5V but not even close to the acuall pin.
Changed the UPDI header to be a 3x1 to save board space.
As per request of a guy in my schools robotics club the board now fetures 3 neopixels (couldnt do his other request of a diode on every pin)
Re-jigged the silkscreen labels so they should be acually readable
Fixed the LT8653S being wired for burst mode ( which is great for battery life, but has higher ripple (I measured 30mV peak to peak with my scope) Now it is wired for FCM (Forced Countiuous Mode) for that super low ripple that the LT8653S is capable of.
I learnt a thing or two about routing and made the pins for everything as close as possible to each other.

Most likely I forgot to mention some stuff that I changed ….

Anyway … turning out to be a genuinely useful board. Had the MVIO comunicating with a 3.3V SD card module yesterday no problems.

Until next time …

ILikeBWRs - Keegan Muller