You are browsing as a guest. Sign up (or log in) to start making projects!

50m 20s logged

Finished AirLog-E!

I’ve finally finished this project!!
But what’s new since last time?

Battery!

The 2000mah lipo finally arrived! (A few weeks after all the other parts tho..) and I could slide it into place inside the enclosure and I have to say.. It was a very snug fit in there!
I then cut off the JST connector from the battery and soldered its + and - wires onto my TP4056’s + and - wires that I had already soldered on. I used a bit of heatshrink tubing to make the connection super secure.

TP4056

I literally just hot glued the TP4056 module on as it wasn’t glued on before!

LED heartbeat

Made the onboard LED flash for 200ms every time the screen updates!

The screen!!

Since last time, the screen looks SO MUCH BETTER!

It now features:

- A big temperature reading, nice and big!

- Humidity readings (same as before)

- VOC readings have a scale now so anything under 100 is ‘Good’, anything between 101-200 is ‘Fair’ and anything over 200 is ‘Bad’.

- Temp and VOC graphs that show you data from the last 4ish hours. (Stored in RTC memory so it survives deep sleep)

- Battery icon, shows the battery % (more on this later)

- The time it last updated

The screen updates every 5mins at the moment! I would do partial refreshes more often but it can’t do those as it forgets what the screen is currently showing when it goes into deep sleep so I can’t do them..

Extra battery stuff

At this current stage, you can’t see the battery % on the e-ink or in home assistant! This is simply due to it getting to crowded with wires inside and I couldn’t fit another wire and 2 resistors! If I (or anyone else) ever do manage to fit it in, you can flip a switch in home assistant and the % will appear on the screen!

As for battery life, I’ve had it running normally for 5 days so far without a charge! I’ll put the final results on the github repo when it eventually dies!

That’s it!

It’s been so cool to make this project - thank you Hackclub and Stardance team!

(I’ve also attached a video to this devlog and to the github repo, for the custom (hopefully 10x) multiplier)

0
29

Comments 0

No comments yet. Be the first!