Hidden Timer Devlog 9

PCB AGAIN 😭

I started designing the case, and then I wondered what wall dimensions would be so I would look at the mounting holes, then I realized that my mounting holes were probably too close to the edge, so I tried eyeballing it around and I realized that would not work, then I changed the grid so the measurements would be more accurate, then I found that my XIAO was too close to the edge for the holes. After all of that, I made a PCB I was happy with, where the holes weren’t too close to the edge, and the XIAO was far away from the wall. Then, when I looked on the guide for the sandwich casing, I realized that the PCB didn’t even need mounting holes. To reduce cost, I wanted to keep the board as small as possible so removed the holes and made the PCB smaller. At least the wiring got cleaner by moving the XIAO