Today I mainly focused on the TVC mount, There were many avalible models online and using them as refrence I created this, The mount uses sg90 tower servos, and m3 push rods. For the rocket motor I chose the F15 because it has a bunch of documentation on it and has a very predicatable thrust curve. I first began by modeling the motor mount and added a engine block at the top to prevent the motor from flying into the rocket. I then worked on the x and y axis and made sure that everythign was specced to the right dimensions to decrease slack. Other than that I also did some small work on the open rocket sim but didnt record like usual. The final steps will be to design the landing legs which will proably take the longest and finish up the launch pad, and create a full assembly.