Completed routing and silkscreen:
okay so last time everything was setup for routing and i just had to manually route everything,
i had to make sure the usbD- and usbD+ were impedance matched with the specifications and also were almost the same length with some tolerance under the usb2.0,as the layout was pretty much done before i routed everything and solved every drc errors, after that i added ground pour for the board,as the ESP32 datasheet suggests adding gnd vias for proper thermal management and noise reduction, i added a hell lot of vias
I also added fillets on the pcb for a better look,for the silkscreen i labeled every GPIO pin and also marked BOOT and RESET buttons, for better look i also added doodles on my board some of them are made by me! :))