|Drafted PCB Routing| In the many routing sessions, I was able to completely connect the components on the PCB to each other. The first thing I did was set the second layer to the ground plane in order for all components to have a reference layer. Then, I proceeded to route the power section. I used multiple power puddles, which is a new method that I am trying out. After the power section, I routed the MCU to the Sensors, and then did the RF section. For the RF section, I made sure to add tons of vias in order to protect the sensitive RF line from noise. When refining the routing, I had to reroute many things in order to make space; this is what took the most time of out the whole PCB routing session. All in all, I am ready to start finalizing the draft, and most likely, I am going to ship this project next session.