Worked on the place where the components will go and how they will be wired togethor.

Things i had to think about:

1. Spacing out components and sitting the heavier ones in the correct location for weight and balance.

2. I had to think about the CG (centre of gravity) this should be at the peak thickness of the wing or in my case 3cm from the leading edge.

3. Also had to think about components getting hot and allowing them enough airflow.

And also what fastening system to use for the hatch to access the battery…
Magnets… a bit heavy
Tape….. a bit weak
Ziptie…… impractical
A 3d printed locking mechanism!!!