Devlog #1
What i did today 😸
today i did the basic cad designs of the side rails of the crawler (if you are not sure what a crawler is its basically a rc offroad expedition-y vehicle that has high toque and power to climb rocks and obstancles, basically a scale down remote controlled truck)

I realised after a while that the 12mm i had the chassis vertical width or whatever was far too small, and at high speed bumps, the aluminium/stainless steel will crack over time, decreasing the longetivity, so thats why i increased it to 20-25 mmon certain points, and even higher on joints and bends because thats whel most stress will be exerted. see below in red:

Whats next??

-Adding cutouts for links and shocks

-Designing drivetrain

-Choosing electronics: Battery motor reciever transmitter servos etc

-Assembling maybe!?!?!