Rocket Prototype | Devlog 11 - The End?

Far from it. I revised the entirety of the Rocket Nose Cone and realised a pressing issue: “you can’t access the inside of the nose cone.”

Rookie mistake.

On my third design, I decided to separate the nose cone into three components: the shoulder, the actual nose cone/ogive, and an avionics sled for the PCB components to be stored.

(BTW the time recorded for this was ONLY for the sled that I finally finished today - the remaining components were me not being bothered to record [whoops]).

The avionics sled SHOULD be printed out by tomorrow but lets see how that goes!